• Examples

Worked Examples

One laminate and one question per page, worked from the inputs to the answer. Every number is checked against an independent implementation, and some pages compare the theory with published test data.

All
Failure criteria
Laminate theory
Micromechanics
Holes and joints
Structures

Tsai-Wu vs Tsai-Hill

A [0/45/-45/90]s carbon/epoxy laminate under biaxial load. The two criteria name different first plies. See which term makes the difference, then how both compare with the WWFE-I test data.

Failure criteria
Test data
Interactive chart
Free calculator

Why an unsymmetric laminate warps

A [0/90] and a [0/90]s laminate under the same tension. The B matrix of one is zero and of the other is not. See which one stretches flat and which one bends.

Laminate theory
Interactive chart
Free calculator

Ply stresses in a [±45]s laminate

A [45/-45]s laminate under tension, worked from the A matrix to the stresses in each ply. Then move the ply angle from 0 to 90° and watch the stresses and the safety factor change.

Laminate theory
Interactive chart
Free calculator

Off-axis strength: theory against test data

One unidirectional E-glass/epoxy ply pulled at 0 to 90° off its fibers. Max stress, Tsai-Hill and Tsai-Wu against the measured strengths, with a slider for the ply stresses at failure.

Failure criteria
Test data
Interactive chart
Free calculator

From fiber volume fraction to laminate stiffness

T300/epoxy from Vf 0.3 to 0.7: ply moduli by rule of mixtures, then Ex, Ey and Gxy of a [0/45/-45/90]s laminate. Each step opens in its calculator.

Micromechanics
Interactive chart
Free calculator

Open-hole strength vs published tests

Fifteen IM7-8552 open-hole tension specimens, holes from 2 to 25.4 mm. The point stress check at its defaults and with d0 calibrated on one test, against the measured strengths.

Holes and joints
Test data
Chart
Dashboard tool

Elliptical cut-outs vs published tests

Circles and ellipses with a/b = 2 and 5 in two AS4/3502 layups. Here the 1.5 mm default d0 overpredicts, which is why you fit d0 to your own coupons.

Holes and joints
Test data
Chart
Dashboard tool

Bolted joint strength vs published tests

Six IM7-8552 double-shear joints: point stress at the defaults, with an open-hole d0 and the characteristic curve. Then single-lap and pull-through tests.

Holes and joints
Test data
Chart
Dashboard tool

Ply stresses in a ±55° pressure tube

A closed-end E-glass/epoxy tube under internal pressure. Move the winding angle and see why ±55° carries the 2:1 hoop to axial load best, then what an unsymmetric [0/45/90] wall does.

Structures
Interactive chart
Dashboard tool
Run your own laminate

The laminate examples open a free calculator with their inputs filled in. Change one value and the results update as you type.

Open the calculators
Written by Rick Schrijver
Share