Maximum Stress Failure Criterion
The maximum stress criterion for a composite ply: the five checks, how the failure index and safety factor follow, and one ply worked by hand.
What the maximum stress criterion predicts
Maximum stress compares each ply stress with its own strength. σ1 along the fibers goes against S1t or S1c, σ2 across them against S2t or S2c, and the shear τ12 against S121. The ply fails when any one ratio reaches 1, and the ratio that gets there first names the mode: fiber, matrix or shear.
The checks are independent. A ply at 90% of its shear strength and 90% of its transverse strength passes, even though both stresses load the same matrix. That is the whole assumption, and the whole weakness.
Maximum stress belongs to the no-interaction family. The cards draw each family's failure envelope for the same ply in the σ1-σ2 plane, with no shear.
Each stress, or each strain, is checked against its own limit. Max stress draws a box with sharp corners. Max strain draws a slanted box, because the Poisson effect puts some σ1 into ε2.
All stresses go into one quadratic expression. The envelope is one smooth, ellipse-like curve, and it does not say whether the fiber or the matrix failed.
Fiber and matrix failure get separate checks. The envelope is pieced together from one curve or line per mode.
Also in this family, not drawn: Cuntze, Sun, Edge.
When to use maximum stress
Use it as a quick first check, for loading that is close to uniaxial in the ply axes, and when you want the failure mode with no extra inputs. Under combined loading it can be non-conservative because it ignores how the stresses interact. Run an interactive criterion such as Tsai-Wu next to it, or a mode-based one such as Puck.
Maximum stress formula
The ply fails when any of these holds1:
All strengths are entered as positive numbers. The sign of σ1 and σ2 picks the tensile or the compressive strength. The sign of τ12 does not matter.
Failure index and safety factor
The failure index is the largest of the five ratios, and the safety factor is SF = 1/FI. Every ratio is linear in the stresses, so doubling the load doubles FI and halves SF. The overview covers safety factors and margins for all criteria.
Worked example: one ply
Take the +45° ply of the quasi-isotropic laminate example. It is T300/5208 carbon/epoxy, with S1c = 1500 MPa, S2c = 246 MPa and S12 = 68 MPa. Its stresses are σ1 = −93.31 MPa, σ2 = −6.69 MPa and τ12 = −40.01 MPa. Both normal stresses are compressive, so the compressive strengths apply.
| Fiber compression, −σ1/S1c | 0.06221 |
| Matrix compression, −σ2/S2c | 0.0272 |
| Shear, |τ12|/S12 | 0.5884 |
Shear governs by a wide margin. FI = 0.5884 and SF = 1/FI = 1.7, so the load can grow by about 70% before the ply fails in shear. The fiber and transverse ratios play no part in the answer. An interactive criterion would add them in.
Limitations
- No stress interaction. Under biaxial stress the ply can fail at lower individual stresses than the criterion allows, so it can be non-conservative.
- Transverse compression does not raise the shear strength here, although it does in tests. Puck and Sun model that effect.
- It predicts first-ply failure only. What the laminate carries after that is a progressive failure question.
Frequently asked questions
References
- Jones, R.M., Mechanics of Composite Materials, 2nd Ed., Taylor & Francis, 1999.